Tomahawk Steak - A Double Cut Bone-In Ribeye Reverse Seared

The tomahawk is the granddaddy of steak. It's a very large double-cut ribeye with the bone in. It's big, it's beefy and it's a carnivore lovers dream steak.

The bone is typically Frenched, meaning that excess fat and meat have been trimmed off the bone. The rib bone adds some flavor and protects part of the steak from the high heat of the grill. It also gives the steak the appearance of a tomahawk, hence the name. If you like a ribeye, give this a try.

Choice vs. Prime

A tomahawk is one of those steaks where the quality of the meat really matters. Choice meat is good for a lot of cuts, but, in my opinion, a tomahawk steak is not one of them. Think about it. A prime rib roast is cooked at 250°F for 3 - 4 hours to make it tender. A bone-in ribeye is basically the same cut of meat but it is cooked fast like a steak, not low and slow like a prime rib roast. That means there is no time for the meat fibers to break down to make the steak tender.

This is where quality comes in. In my experience, a high quality prime ribeye is more tender than a choice ribeye. A prime steak will have more fat and should be more tender than a choice steak. If you can find a prime tomahawk steak, I think it worth the extra money.

A tomahawk steak pairs well with Corn Ribs, Texas Style Creamed Corn with Poblano Peppers and Barbecue Baked Beans.

Also, see my post Best Beef: A Comprehensive Guide to Popular Cuts of Steak.

Cooking Method

There are really only a few ways to cook a tomahawk steak. Sous-vide with a reverse sear is hard to do because the tomahawk steak is so darn big it's a challenge to get the whole thing in a sous-vide bath. Reserve sous-vide for another cut of meat. A cast iron skillet is also not really an option, the tomahawk will not fit.

That means it's time to break out the grill. For this recipe, I setup my Kamado Joe setup for indirect heat at 300°F. I cooked the steak to an internal temperature of 105°F and then removed it from the grill, tented it with aluminum foil, and let it rest for 10 minutes while I reconfigured the grill for direct, high heat. The steak was then seared for about 90 seconds on each side and then served immediately. There was no need to rest it again A gas barbecue would certainly work but I prefer the flavor and hint of smoke that comes from cooking it over coal. A standard grill, like a Weber, would work if configured for direct heat only on one side of the grill.

In the first video, I cooked the tomahawk in a wood-fired oven on a Tuscan grill grate that I made with some parts from my local hardware store. A few nuts and bolts and a replacement cast iron grate for a barbecue was all it took.

Jump to:

• Choice vs. Prime
• Cooking Method
• Ingredients
• Instructions
• Equipment
• Storage
• Top Tip
• Related
• Pairing
• 📖 Recipe

Ingredients

• A great big tomahawk steak
• Olive oil
• Kosher salt
• Black pepper
• A big appetite

See recipe card for quantities.

Instructions

With a tomahawk steak, less is more. Simple seasonings is all it takes. A little olive oil, salt and pepper is all this steak needs. The beefy flavor is intense and a little char from the sear completes the steak.

Be aware that this cut of meat has a lot of fat and it will cause a flare up. Watch your eyebrows. If you enjoy a good steak, this is worth trying.

Equipment

For this recipe, I used Kamado Joe. A Big Green Egg, pellet grill or an inexpensive charcoal grill would work just fine.

Storage

You won't have any leftovers.

Related

Looking for other recipes like this? Try these:

Pairing

These are my favorite dishes to serve with this recipe.

📖 Recipe